Taper Shank Type Shaper Cutters with DIN 1828
2023-03-26 14:07:45
jiangxingTools
1576
Taper Shank Type Shaper Cutters with DIN 1828
These shaper cutters are 20° PA, non-topping finishing cutters for straight spur gears,
tooth profile of shaper cutters is according to DIN 3972 profile Ⅱ，
there is no center hole on cutting face end of shaper cutter.
More taper is No. 2 and No.4 for above shank type shaper cutters.
相關(guān)文章
-
PA20° Profile DIN3972 Standard Pre-grinding Gear Hob with Module m2
PA20° Profile DIN3972 Standard Pre-grinding Gear Hob with Module m2Tooh profile is according to GB,... - PA20° HSS M2, M35 Gear Cutting Hobs with Semi-Topping Tooth Profile
- Gear Shaving Machine
- Bohler S790 Microclean for Hobs
- Heat-treatment Hardness Standard for Hobs
- PA20° PCD 160mm Disk Type Gear Shaper Cutter with Module m6~m10
- PA30° DIN5480 Involute Spline Hob with Module m2
